Pendulum instructions
PACKAGE APPEARANCE
- One rectangular box with 1 cardboard tube containing the pole section.
- One box containing the hoop and its strap.
- One box containing the hoop and its strap.
PACKAGE CONTENTS
1 Pole Section .
1 Hoop/Lollipop.
1 Hook preinstalled in the hoop pin for threading the strap through.
1 Strap 150 cm long, with a loop.
1 10 mm wrench.
1 5 mm hex key.
1 Instruction Sheet with QR code.
1 Hoop/Lollipop.
1 Hook preinstalled in the hoop pin for threading the strap through.
1 Strap 150 cm long, with a loop.
1 10 mm wrench.
1 5 mm hex key.
1 Instruction Sheet with QR code.
TOOLS NEEDED FOR LINSTALLATION NOT INCLUDED
-Ceiling hook (you can purchase the Albastros with the swivel already built in).
-Rope, strap or a Daisy Chain to attach the Pendulum to the ceiling.
-Swivel which allows the Pendulum to rotate without twisting the ropes (required if the Albatros plate has not been installed).
-Carabiners (as many as needed).
-Rope, strap or a Daisy Chain to attach the Pendulum to the ceiling.
-Swivel which allows the Pendulum to rotate without twisting the ropes (required if the Albatros plate has not been installed).
-Carabiners (as many as needed).
PENDULUM ASSEMBLY
To make assembly easier and faster, the Pendulum is shipped with the strap already inserted into the hoop hook.
Be careful when unpacking the product to avoid damaging the ropes and the pole covering.
The Pendulum must be assembled on the ground.
Kneel down to proceed with the assembly.
To fully assemble the Pendulum, for example to replace the strap, go to step 4.0
Be careful when unpacking the product to avoid damaging the ropes and the pole covering.
The Pendulum must be assembled on the ground.
Kneel down to proceed with the assembly.
To fully assemble the Pendulum, for example to replace the strap, go to step 4.0
INSERT THE STRAP INTO THE POLE
1st Place the hoop and pole on the floor.
2nd Insert the strap into the pole and pull it out the other side
Avoid dragging the pole section across the floor.
CAUTION! DO NOT TWIST THE STRAP, avoid rotating the pole and hoop on the longitudinal axis.
INSERT THE RING INTO THE POLE AND TIGHTEN THE LOCKING KNOB
1st, insert the ring pin into the pole section, align the hole with the locking knob. WARNING! DO NOT TWIST THE WEBBING.
2nd Tighten the joint clockwise using the 5 mm hex key, tightening firmly.
Never twist the webbing inside the pole.
THE PENDULUM IS ASSEMBLED; YOU CAN NOW PROCEED WITH INSTALLATION
Once assembled, the Pendulum can be installed by attaching it to the ceiling.
Go to INSTALLING THE PENDULUM
Go to INSTALLING THE PENDULUM
INSTALLING THE PENDULUM
The Pendulum must be installed beneath a suitable ceiling or beams.
WARNING! Always use a swivel to prevent the webbing from twisting. If you purchased our Albatros plate, the swivel is already built into the plate.
WARNING! Always use a swivel to prevent the webbing from twisting. If you purchased our Albatros plate, the swivel is already built into the plate.
ATTACHING THE PENDULUM TO THE CEILING
CONNECTING THE POLE TO THE CEILING WITH THE ALBATROS PLATE:
1st Attach the first carabiner to the webbing.
2nd Attach the rope, webbing, or daisy chain (not included) to the carabiner; this will connect the pole to the ceiling.
3rd Attach the second carabiner to the end of the rope, webbing, or daisy chain.
4th Attach the second carabiner to the Albatros plate
CONNECTING THE POLE TO THE CEILING WITHOUT THE ALBATROS PLATE:
1st Attach the carabiner + swivel + carabiner to the webbing.
2nd Attach the rope, webbing, or daisy chain (not included) to the carabiner; this will connect the pole to the ceiling.
3rd Attach the third carabiner to the end of the rope, webbing, or daisy chain.
4th Attach the third carabiner to the ceiling hook.
1st Attach the first carabiner to the webbing.
2nd Attach the rope, webbing, or daisy chain (not included) to the carabiner; this will connect the pole to the ceiling.
3rd Attach the second carabiner to the end of the rope, webbing, or daisy chain.
4th Attach the second carabiner to the Albatros plate
CONNECTING THE POLE TO THE CEILING WITHOUT THE ALBATROS PLATE:
1st Attach the carabiner + swivel + carabiner to the webbing.
2nd Attach the rope, webbing, or daisy chain (not included) to the carabiner; this will connect the pole to the ceiling.
3rd Attach the third carabiner to the end of the rope, webbing, or daisy chain.
4th Attach the third carabiner to the ceiling hook.
FULL ASSEMBLY OF THE PENDULUM OR REPLACEMENT OF THE WEBBING
These instructions explain how to fully assemble the Pendulum.
WARNING: The strap supplied by the company with the product is made to specific technical specifications and has a specific breaking load. Replacing it with unsuitable or low-quality rope may cause accidents and serious injuries.
Please contact the company for original replacement parts at office@brasiliamoda.com
WARNING: The strap supplied by the company with the product is made to specific technical specifications and has a specific breaking load. Replacing it with unsuitable or low-quality rope may cause accidents and serious injuries.
Please contact the company for original replacement parts at office@brasiliamoda.com
REMOVE THE SAFETY SLEEVE
Grasp the safety sleeve with your fingers and pull it all the way off.
UNSCREW JUST ONE SCREW WITH THE 10 MM WRENCH
1st Lower the rope stop.
2nd Using the 10 mm wrench, unscrew and remove just one screw.
2nd Using the 10 mm wrench, unscrew and remove just one screw.
INSERT THE NEW STRAP
Insert a new strap.
WARNING: The strap supplied by the company with the product is made to specific technical specifications and has a specific breaking load. Replacing it with unsuitable or low-quality rope may cause accidents and serious injuries. Please contact the company for original replacement parts.
WARNING: The strap supplied by the company with the product is made to specific technical specifications and has a specific breaking load. Replacing it with unsuitable or low-quality rope may cause accidents and serious injuries. Please contact the company for original replacement parts.
TIGHTEN THE SCREW UNTIL IT STOPS
1st With the 10 mm wrench, tighten the screw completely until it stops. Make sure to insert the wrench correctly into the screw head to prevent premature wear.
2nd Use a pencil to make sure the two screws are at the same height.
This check is very important for safe use of the product and to ensure that the safety sleeve can be inserted correctly.
INSERT THE SAFETY SLEEVE
1st Make sure the screws are positioned as shown in the photo.
2nd Insert the safety sleeve.
2nd Insert the safety sleeve.
ASSEMBLE THE PENDULUM
DISASSEMBLING THE PENDULUM: SEPARATING THE RING FROM THE POLE
Place the Pendulum on the ground in a horizontal position before proceeding.
1st Using the 5 mm Allen key, unscrew the pole pin by 3.5 turns.
WARNING: DO NOT TURN THE ALLEN KEY COUNTERCLOCKWISE TOO MANY TIMES, OTHERWISE THE STEEL PIN WILL COME OUT THE OTHER SIDE AND BLOCK THE JOINT. IF THIS HAPPENS, SCREW THE STEEL PIN BACK IN CLOCKWISE WITH THE 5MM ALLEN KEY UNTIL IT STOPS, THEN UNSCREW IT COUNTERCLOCKWISE BY ONLY 3 TURNS.
2nd Rotate the pendulum until the silver pin is visible, then use the hex key to push the pin inward.
3rd Gently pull the hoop and pole apart.
PRE-USE CHECKS
7.1 BEFORE EVERY USE, check that the joint is always securely tightened.
7.2 BEFORE EVERY USE, check that the rope or strap is not damaged or worn. If it is, replace it immediately and DO NOT use the Pendulum.
7.3 Ensure that all hanging accessories are suitable for the intended use.
7.4 Ensure that the equipment is used by experienced people and provide any necessary fall-protection accessories (such as safety mats).
7.2 BEFORE EVERY USE, check that the rope or strap is not damaged or worn. If it is, replace it immediately and DO NOT use the Pendulum.
7.3 Ensure that all hanging accessories are suitable for the intended use.
7.4 Ensure that the equipment is used by experienced people and provide any necessary fall-protection accessories (such as safety mats).
MAINTENANCE
8.1 Cleaning the GeckoGrip pole: use plain alcohol (preferably isopropyl) on a microfiber cloth.
Wear personal protective equipment when cleaning. We recommend ventilating the room after cleaning the pole.
8.2 Replace the ropes periodically, or immediately if damaged and/or worn.
Wear personal protective equipment when cleaning. We recommend ventilating the room after cleaning the pole.
8.2 Replace the ropes periodically, or immediately if damaged and/or worn.
WARNINGS
9.1 The tools required for assembly, installation, and dismantling are supplied. Before using any other tools on the pole, contact Technical Support to confirm that the work is suitable.
9.2 Always take the utmost care and follow the instructions during all stages of assembling, installing, and dismantling the product.
9.3 If in doubt, contact customer support.
9.4 Do not allow unqualified people or minors to use, install, or move the product unless supervised.
9.5 As a piece of sports equipment, the product must be used by competent and trained people.
9.6 Do not perform moves you are unable to do without supervision.
9.7 Use suitable safety equipment and certified mats.
9.8 For use of the pole raised off the ground, choose the UltraGrip (rubberized) coating.
POLEDANCETRADING.COM WILL NOT BE LIABLE FOR ANY DAMAGE TO PROPERTY OR INJURY TO PERSONS CAUSED BY IMPROPER USE OF THE PRODUCT.
9.2 Always take the utmost care and follow the instructions during all stages of assembling, installing, and dismantling the product.
9.3 If in doubt, contact customer support.
9.4 Do not allow unqualified people or minors to use, install, or move the product unless supervised.
9.5 As a piece of sports equipment, the product must be used by competent and trained people.
9.6 Do not perform moves you are unable to do without supervision.
9.7 Use suitable safety equipment and certified mats.
9.8 For use of the pole raised off the ground, choose the UltraGrip (rubberized) coating.
POLEDANCETRADING.COM WILL NOT BE LIABLE FOR ANY DAMAGE TO PROPERTY OR INJURY TO PERSONS CAUSED BY IMPROPER USE OF THE PRODUCT.